Etobicoke is dominated by detached bungalows, side-splits, and two-storeys built between the late 1940s and the 1970s, plus a growing band of lakeshore condos through Mimico and Humber Bay Shores. In the detached stock we mostly replace mid-efficiency furnaces that were installed in the 1990s and early 2000s and are now at the end of their run, usually with a high-efficiency Lennox, Carrier, or Trane unit sized to a proper load calculation.
The Kingsway and Islington Village have larger homes with longer duct runs and, in many cases, additions that were never rebalanced. Getting airflow right there matters more than raw furnace size, so we check static pressure and CFM rather than just swapping in a bigger unit. Where an addition or a bungalow's upper half-storey has no ductwork, ductless air conditioning with a mini-split is usually the cleanest fix.
Rexdale and Thistletown hold more 1960s semis, townhouse complexes, and rental properties. When a high-efficiency furnace vents out the side wall, the old water heater is often left alone in an oversized chimney, so we check that venting on every replacement there, and many owners switch to a tankless water heater at the same visit.
Closer to the lake, the microclimate is milder and damper. Long Branch, Alderwood, and New Toronto homes often need better dehumidification in summer and see more condensate and drainage issues, so we pay particular attention to condensate routing and coil sizing in those installs.
Our specialty 
